Westbay Optic Fiber Light Engine Driver Kit 32W RGBW Double Port Fibre Optiq Source With Touch Panel For Ceiling Star | Лампы и

Westbay Optic Fiber Light Engine Driver Kit 32W RGBW Double Port Fibre Optiq Source With Touch Panel For Ceiling Star | Лампы и

Westbay

Better Choice, Better Life

NEWEST Touching panel controller +32W RGBW Led optic fiber light engine, DIY light

Package included:

1. 1pc 32W RGBW double ports led Engine

2. 1pc Black Touching Glass panel controller 

3. 1pc Power adaptor

4. 1pc User instruction

5. 900pcs 0.75mm*3m optic fiber

or 500pcs 1.0mm*3m optic fiber

or 200pcs 1.5mm*3m optic fiber

or 120pcs 2.0mm*3m optic fiber

Real photo Showing:

The number of optical fiber can be installed：

Connection method between Fiber and Led engine:

1.Align all the fiber head, fasten with tapes which can resistance temperature over 130℃

2.Pass through the fiber to connector, fastening rotary tensioner. To make sure the fiber bunch could not move and each fiber must be in the same plane.

3.Cut the fiber bunch to flat surface by heat-knife or blade. 

4.Make sure the fiber bunch head is smooth and clean. Thus each fiber’s light will be evenly.

5.Put through the whole fiber connector to fix ring of Led engine. Fasten screw on the top of the fix ring.

Controller Matching Code Instruction:

1.You don't need to match code if it is used alone.

To match the remote control to the receiver (you do not need to do this when first out the box). Press “brightness-” Key once when first switched on within 3 seconds. This light will blink 3 times to indicate that the remote control is matched.

2. Matching Steps:

3.Clearing mode:

Press “brightness+” Key once when first switched on within 3 seconds, the light will blink 6 times if clearing is successful.

Effection Mode from Touching Panel :

Application installation diagram:

Attention:

1.Make sure the input voltage is correct.

2.Put led engine in the rain or moist place is prohibited

3.Please don’t open led engine for inspection or change the electronic circuits if you are not professionor.

4.Led engine has to be good ventilation, please don’t put at sealed place.

5.Put debris on top of led engine or around it will be caused poor heat dissipation.

Related Proudcts: