SWG-25 Ручная трубогибочная машина 0.8-2.0мм Железо/Медь/ПВХ/Пластик У-образный механический гнуток.

SWG-25 Ручная трубогибочная машина 0.8-2.0мм Железо/Медь/ПВХ/Пластик У-образный механический гнуток.

Unavailable in 

Purchase notice:
1. Any customs duties or import taxes during customs clearance must be paid by the buyer. If the buyer is unwilling to pay, we will not refund.
2. For countries that are difficult to pass through customs, please ensure that you have the ability to pass through customs. If the buyer fails to pass the customs and the customs deducts the package, we will not issue a refund.
3. If your address is a remote address, you need to pay an additional delivery service fee of $40.
4. We ship 220v by default. If the plugin cannot customize your local plugin, please use the plugin converter.
Parameter:
Model: SWG-25S
Bending wall thickness: 0.8-2.0mm
Bending range: 10-25mm
Packing: plastic box
Bending angle: 0~180 degrees
Bending mold: 10, 12, 14, 16, 19, 22, 25 each set
Bending
objects: used to bend thin-walled pipes with a thickness of 0.8-2mm and
stainless steel pipes in the diameter of 10-25mm.
Product
features: Installed on a firm workbench, equipped with 7 180-degree
pipe bending molds, easy to operate, labor-saving, and suitable for all
kinds of round pipe bending, non-bendable square pipe. Good bending
effect, not easy to deform
Bending angle: 180°
Tube Thickness: 0.8-2.0mm
Bending mould: 10,12,14,16,19,22,25

SWG-25
manual pipe bender is the cold bending type simple manual pipe
bender.Without heating filling sand, etc.Small bending arc smooth,
clear, deformation.Easy to use, easy to carry.Suitable for factories and
mines, rural, chemical, refrigeration, building, electrical wiring,
pipe installation, is a commonly industry used tool.

Method of use:
A) the first fixed base.
B) according to the required bend sizing to choose the mould and roller.
C)
when using put the mould into the shaft on the base, then set the
bracket into the shaft, then put the wheel in the locating piece, bolted
fixed.
D) transfer bracket to the wave plate, the bent pipe is
inserted between the mould and the roller, adjust the nut, let the
mould, tube, wheel joint.Then turn the handle.